KAD/ENC/106 4 Ch. IRIG-106 PCM encoder

  • Downloads
  • SPECIFICATIONS
  • SUPPORT
  • REQUEST A QUOTE

Features

  • Sixth order linear phase (Bessel) PMF with programmable cutoff from 175kHz to 6MHz and output voltage from ±0.5Vp to ±5Vp
  • Up to 10 PCM codes at up to 20Mbps
  • 2 to 250K words per major frame and 4 to 8K words per minor frame
  • 5 to 64 bits and parity (odd/even/none) programmable word by word
  • Supports any sync word and sub-frame strategy

Applications

  • RF transmission of PCM streams
  • Encode data in IRIG-106 Ch.4 PCM stream
DAS Studio 3 Setup software for DAUs, network switches, recorders and ground stations

DAS Studio 3 Setup software for DAUs, network switches, recorders and ground stations

Setting up data acquisition systems can take a lot of time and effort, particularly as many systems today are growing larger and larger. Managing thousands of channels of data over dozens of data...

KAD/BCU/140 Ethernet backplane controller - IENA/iNET-X compatible with TFTP programming

KAD/BCU/140 Ethernet backplane controller

The KAD/BCU/140 is a full-duplex, Ethernet, Acra KAM-500 backplane controller packet programmer and an IPv4 data packets transmitter (via a 100BaseTX link interface). The Acra KAM-500 backplane...

KAD/ENC/111 CCSDS encoder (Ethernet interface, internal 64 MB memory buffer)

KAD/ENC/111 CCSDS Encoder

The KAD/ENC/111 is a CCSDS encoder with Ethernet interface and a 64 MB internal memory buffer. It is used to wrap UDP packets received over Ethernet into CCSDS frames of fixed length of 1,279...

CONTACT SALES/SUPPORT

We’d like to keep in touch and send you updates on our products, news and developments – please tick below to make sure you don’t miss out. You can unsubscribe at any time by clicking on the unsubscribe link at the bottom of the emails. Your personal information will not be shared with any person or organization outside of Curtiss-Wright. Review our privacy policy.


4 channel, IRIG-106 PCM encoder with PMF output

The KAD/ENC/106 is used to encode data from any KAM-500 module in an IRIG-106 Ch.4 PCM stream. Multiple KAD/ENC/106 modules can be included in a KAM-500 system and parameters can be sent to some or all encoders. In particular, a system can have four encoders at different codes, data rates, word lengths and frame lengths. The only restriction is that an integral number of major frames be transmitted per acquisition cycle.

Parameters to be transmitted are stored in predefined locations in RAM. Each parameter has a word definition which includes the location in RAM, bits per word, MSB sent first/last and parity. This definition controls the RAM reader and the parallel-to-serial converter. The KAD/ENC/106 has differential ended RS-422 outputs for data and clock along with buffered TTL outputs for NRZ-L, DATA, DCLK, word, minor-frame and major-frame pulses. The KAD/ENC/106 also has a programmable premodulation filtered analog output which is suitable for use with a linear FM transmitter for telemetry. The cutoff frequency and amplitude can be changed to suit the bit-rate and transmitters deviation sensitivity.

Product Finder

Connect With Curtiss-Wright Connect With Curtiss-Wright Connect With Curtiss-Wright
Sales

CONTACT SALES

Contact our sales team today to learn more about our products and services.

YOUR LOCATION

PRODUCT INFORMATION

Support

GET SUPPORT

Our support team can help answer your questions - contact us today.

REQUEST TYPE

SELECT BY

SELECT Topic